Version 01.03.2022
HW:CAM(V100)/(V47)
RL4-MBMRT
P
a
g
e
12
2.4.2
Connection - 31pin PNP cable (
analogue without CAN-bus
)
Cut all the blue and grey wires of the enclosed 26-pin PNP cable close to the
10-pin connector and insulate all 8 cable ends.
Connect the enclosed 26
pin PNP cable’s female 10pin connector to the male
10pin connector of the video interface.
Disconnect the female 26pin connector of the factory harness at the rear-side of the head-
unit and connect it to the male 26pin connector of the enclosed 26pin PNP cable.
Connect the opposite female 26pin connector of the enclosed 26pin PNP cable to the
previously become free male 26pin connector of the factory head-unit.
Attention: For analogue connection (without CAN bus), the violet wire of the 12-pin
interface cable must also be connected to +12V or +24V ACC accessory power
(see chapter
„
Connection
–
switching input by 12pin interface cable (with analogue
connection without CAN-Bus
)“.