Version 09.02.2023
HW: CAM(V31)/(V22)
RL2-MZD
P
a
g
e
12
2.7.
After-market rear-view camera
For the function of the rear-view camera, an external switching signal from the reverse gear
light is required. As the reverse gear light signal contains electronic interference, use a
traditional open relay (e.g AC-RW-1230 with wiring AC-RS5) or filter (e.g. AC-PNF-RVC).
The schema below shows the use of a relay (normally open).
Connect the 6pin cable’s green wire both to output connector (87) of the relay.
Connect the Reverse light’s power-cable to coil (85) and the vehicle’s ground to coil
(86) of the relay.
Connect the output connector (87) of the relay to the rear-view camera’s power-
cable, like you did it to the 6pin cable’s green wire before.
Connect stabile and per12V to the relay’s input connector (30).
Note: Set dip5 of video-interface to ON.
