Version 07.02.2023
HW CAM(V31)/(V22)
CI-RL1-RLK
P
a
g
e
6
1.3.1.2.
Enabling the interface’s video inputs (dip 2-3)
Only the enabled video inputs can be accessed by switching through the interface’s video
sources. It is recommended to enable only the required inputs, because the disabled inputs
will be skipped while switching through the video interfaces inputs.
1.3.1.3.
Rear-view camera setting (dip 5)
If set to OFF, the interface switches to factory LVDS picture while the reverse gear is engaged
to display factory rear-view camera or factory optical park system picture.
If set to ON, the interface switches to its rear-view camera input while the reverse gear is
engaged.
1.3.1.4.
Monitor selection (dip6, 7-and 8)
Set to OFF
Note:
Dip 1 and 4 are out of function and have to be set to
OFF
.
2.
Installation
Switch off ignition and disconnect the vehicle’s battery! The interface needs a permanent
12V source. If according to factory rules disconnecting the battery is to be avoided, it is
usually sufficient to put the vehicle to “Sleep-Mode”. In case it does not succeed,
disconnect the battery with a resistor lead.
If power source is not taken directly from the battery, the connection has to be checked
for being start-up proven and permanent.
2.1.
Place of installation
2.1.1.
Place of installation – video interface
The interface boxes shall be installed behind the vehicle`s head-unit or the glove
department, depending on equipment and space.
2.1.2.
Place of installation - daughter PCB
The interface’s daughter PCB is prepared to be installed between the head unit’s housing
and the monitor panel.
For this purpose the housing of head-unit have to be opened.
