Version 07.02.2023
HW CAM(V31)/(V22)
CI-RL1-RLK
P
a
g
e
13
2.5.1.
After-market rear-view camera
Note: S
et dip5 of video-interface to ON.
To switch to the rear-view camera when reverse gear is engaged, an external switching
signal from the reverse gear light is required. As the reverse gear light signal contains
electronic interference, a traditional open relay (e.g AC-RW-1230 with wiring AC-RS5) or
filter (e.g. AC-PNF-RVC) is required. Below schema shows the use of a relay (normally open).
Connect the green
switching input cable
to the output connector (87) of the relay.
Connect the Reverse light’s power-cable to coil (85) and the vehicle’s ground to coil
(86) of the relay.
Connect the output connector (87) of the relay to the rear-view camera’s power-
cable, like you did it to the green
switching input cable
before.
Connect stabile and per12V to the relay’s input connector (30).
