Navistar WorkStar Series, Руководство оператора

Страница: 187 / 258

Maintenance Instructions
control, and desiccant quantity. Regularly check the desiccant,
purge valve and air dryer heater performance.
Desiccant Filter
Open reservoir drain valves and check for presence of water.
Small amounts of water due to condensation is normal. If the
wet, primary, or secondary tanks are collecting an abnormally
high amount of water between regular air tank drain intervals,
replace the air dryer desiccant.
The air dryer desiccant replacement interval may vary; it is
generally recommended that the desiccant be replaced every
12 months for small air dryers, like the Bendix AD-IP®, or every
24 months for large air dryers, like the Bendix AD-9® or Bendix
AD-IS®. If experience has shown that extended or shortened
life has resulted for a particular installation, then the interval
should be increased or reduced accordingly.
Purge Valve
Check that the purge valve opens and expels moisture when
the air governor shuts off the air compressor. Air should escape
rapidly and then quickly stop. If the purge valve does not open
or you can hear a slight audible air leakage past the valve for
longer than 30 seconds, the valve may be sticking and should
be rebuilt. Purge valves may also stick if the air dryer heater has
failed and ice is clogging the valve.
Heater
Check that the air dryer heater activates at temperatures below
freezing. With the vehicle in a cold environment and before the
engine is started, turn on the ignition and touch the air dryer
housing. It should be warmer than other metallic items on the
vehicle. If some warmth cannot be felt, it may indicate that the
heater element or the wiring powering it should be serviced.
Air Reservoir/Tanks Moisture Draining
Moisture taken in with the air through the compressor inlet valves
collects in the air tanks. The wet tank is the first tank to receive
air from the air drier and therefore collects most of the remaining
moisture that was not removed by the air dryer. Drain the wet
tank reservoir every day at the end of the trip. Drain the primary
and secondary tanks periodically. Periodically, manually drain
each reservoir by opening the drain cock located either on the
bottom of the tank or in the end of the tank. Make sure the
drain passage is not plugged. For ease of draining, some or all
air tank drain valves may be equipped with optional pull cords.
There must be some air pressure in the system to ensure proper
drainage. Close the drain cocks after all moisture has been
expelled. Drain the wet tank daily at the end of each trip to purge
collected water and prevent ice formation inside the tank when
the vehicle is shut off in cold weather. If you are unsure which
tank is the wet tank, drain all tanks daily.
On vehicles equipped with automatic drain valve(s), moisture
and contaminants are automatically removed from the reservoir
to which it is connected. It operates automatically during each
compression cycle and requires no manual assistance or control
lines from other sources.
3879634R1
175