NAVIOR-24S
™
CHAPTER 1
Starter Kit
30
NAVIOR-24S ™
Revision
V1.00 20.05.2008
Quick start instructions for using the STOREGIS application to monitor the receiver’s performance
are given below.
Note
– If there is no connection, GPS/GLONASS module may not be communicated with the
computer. Re-check the interface cable connections and verify the serial port selection and settings.
If the communication failure continues after checking all connections and settings, please call the
NAVIS Technical Assistance Center.
1. Connect one end of the serial interface cable to Port “COM 2” of the interface unit.
Connect the other end of the cable to the COM port of your PC
2. Turn on the DC power source or plug in the AC/DC converter.
3. Insert the CD in the computer’s CD-ROM drive.
4. The STOREGIS program may be run directly from the CD or it may be copied onto your
computer’s hard drive. To run the program from the CD, initiate the storegis.exe file.
5. Use setting
СОМ
port
РС
according to Appendix D - NMEA Tool kit User’s Guide
7. After a GPS/GLONASS antenna is connected to the receiver and the receiver has
achieved a position fix, the transmitted position reports, time, velocity, satellites tracked,
and GPS/GLONASS receiver status appears on the screen.