NAVIS NavDP 4000. Operation Manual
9.3.6
Position by Target Control
The vessel position is automatically controlled in this mode according to relative position of the vessel and the target(s).
See Figure 9.12.
Figure 9.12: Position by Target Control
See Section 10.5, page 180 that describes how to assign the targets, operate in the
Target
window and set the param-
eters for following the target.
In this mode the vessel heading can be controlled either automatically or manually. See Section 10.5, page 180 for
more detailed information.
9.3.7
Position mode: LS Track Control
The vessel position is controlled automatically in this mode according to relative position of the vessel and the track
see Figure 9.13.
The vessel heading can be controlled either manually or automatically.
See Section 10.6, page 189 that describes how to set a track(s), operate in the
Track
window and set the parameters
for following the track.
Following options can be used in this mode:
– Waypoint table management (reverse track, copy track, edit points, change active track, external track loading (from
ECDIS, for instance);
– Cross-track alarm;
– Stop at last waypoint;
– Change heading;
– Auto heading by track (with crab angle setting);
– Minimal power heading.
Following parameters are available from Operator Station:
Vessel speed
Vessel speed settings;
WP Pass Strategy
Non-stop and stop strategy (waypoint passing strategy);
Off-Track Limit
Specifies the track offset at which an alarm is produced;
Position Gain
Specifies the tracking accuracy;
169
Doc. 000.JDP-10000-OME, rev.3.3.13/“2102.$–17A-Advanced”
Содержание NavDP 4000 Series
Страница 88: ...NAVIS NavDP 4000 Operation Manual Figure 5 35 Dark Theme 87 Doc 000 JDP 10000 OME rev 3 3 13 2102 17A Advanced...
Страница 222: ...NAVIS NavDP 4000 Operation Manual Figure 10 74 Drift Plot Window 221 Doc 000 JDP 10000 OME rev 3 3 13 2102 17A Advanced...
Страница 324: ...NAVIS NavDP 4000 Operation Manual Figure H 4 Remote DLS Mode 323 Doc 000 JDP 10000 OME rev 3 3 13 2102 17A Advanced...
