NAVCAM-FHD360
USER MANUAL
11
NavCam-FHD360 Manual Ver 2.2 12/2014
Connecting the NAVCAM-FHD360 in the Car
The above wiring diagram shows a left hand drive vehicle. Wiring path is only
a suggestion.
1. CRASHCAM-FHD360 device mounted behind the rear vision mirror.
2. Car charger cable routed behind rear vision mirror.
3. Cable hidden behind roof headlining.
4. Cable hidden behind “A” pillar – beware of airbag equipped cars.
5. Cable is routed beside the dashboard/near the door hinges.
6. Cable is passed under the passenger carpet (or under the dashboard).
7. Car charger plug is connected to the car’s “cigarette socket”.
Installing the rear camera is done in much the same fashion, however the cable is
run 1) under the kick panel next to the passenger seat 2) around and under the seat
belt floor mount 3) under the kick panel next to the rear left passenger seat and lastly
4) behind the rear seat and attached to the rear window.
Once the wiring and installation of the CRASHCAM-FHD360 has been completed, please check the
following:
- With the car’s ignition on (or engine started), the Blue LED indicator on the CRASHCAM-FHD360 will light up
and the LCD screen should turn on. Recording should start automatically. This will indicate a successful
installation.
- When the car’s ignition is turned off, the device should turn off within 20 seconds with the “Navig8r” logo
appearing on the LCD screen. If this doesn’t happen then power is still being supplied to the car charger socket.
and the device will need to be switched off manually.
