18 FAQ
19 SPECIFICATIONS
23
24
Parameter
Name
FN-E1
Size
Vehicle: L × W × H
1135 X500X1178mm
After Folding: L × W × H
1135X500X475mm
Weight
Net Weight
About 16 kg
State
Max. Load
100kg
Main Parameter
Max. Speed
15.5 mph (25 km/h)
General Range
About 40 km (It depends on the environment, angle,
speed, driving habits, etc.)
Max. Climbing Angle
About 12%
Suitable Surfaces
The road surface should be flat and smooth, the road surface bulge should be less
than 2 cm, and the depression should beless than 3 cm
Tire
10-inch pneumatic tire
Shock Mitigation System
Pneumatic Tires
Noisetest
Less than 70 dB
IP Rating
IpX4
Brake System
Rear wheel disc front wheel (motor) electromagnetic brake,braking
distance<Brake system 7m
LED Display
Real-time speed, mileage, gear, braking force, voltage display, speed unit,
headlight status indicator,
Bluetooth, automatic cruise control, fault display
Lamp System
LED front and rearl amps
Motor Power
350W
Charging Parameters
Adapter
54.6 V/2 A/Short Circuit Protection
Lithium Battery
37 VDC, 10 AH
Charging Time
About 7-8 h
车。
When the product fails, please refer to the
following ways to try for solution:
1.The display screen is black.
Reason: this scooter is exposed to sunlamp for a long time.
Solution: put the scooter in a cool place for a period of time.
2.The value is inconsistent with the actual value.
Reason: incorrect or missing parameter setting.
Solution: long press the power button to turn off and then
press to restart the scooter.
3.The digital display is dim.
Reason: poor battery contact or no battery power.
Solution: turn off the power, and then turn it on again. If the
fault still exists after the battery is charged, please contact
the manufacturer or dealer.
4. If the product cannot operate normally,
please check whether the following have
been completed.
a. Check that the power is on.
b. Check the battery level on the display.
c. Check whether the left brake lever and rear disc brake are in
place.
d. Check that all sockets and connectionsare properly connected.
If all steps have been completed and the product still
does not work properly, please contact the
manufacturer or dealer.
5. The controller is damaged. Do not
replace the controller without authorization.
Please contact the manufacturer or dealer,
do not disassemble the product without authorization.
6. The stem is get unstable
Reason: the screw at the joint of the stem and the
folding seat is loose.
Solution: lower the column, loosen the three screws
, raise the column, tighten the screws at the back of
the pole, and then lower the pole and tighten the
three loosened screws to solve the problem.
A
B
C
