Navaid Devices AP-1, Руководство пользователя

Страница: 31 / 32

- A.7 -
To set the course width:
1. Hold the Course/Heading switch either to the left or right when you turn on the
autopilot. You must keep the switch engaged until the LEDs stop their normal turn-on
flashing sequence.
2. There is no indication that you have entered set mode.
3. The coupler is factory-set to a course width of 1.25NM. Push the switch to the
Heading position to increase course width by a factor of two. Push the switch to the
Course position to decrease course width by a factor of two. After each push the
course (green) or heading (yellow) LED will blink to indicate what gain is selected.
You must wait until the course and heading LEDs are no longer blinking before
selecting another gain setting. See the table below.
4. When you are satisfied with the gain, turn the Coupler off to get out of Set Mode.
Course Width Number of blinks
1.25NM 1
2.5NM 2
5NM 3
10NM 4