5. Close flaring bar and move the flaring body
positioned over the tubing. It should click.
6. Tighten tension rod.
Arrow
Mark
7. Using ¼” hex drill bit, insert it to the hex socket
on the expander end. With the drill set for
clockwise turning, start the drill and continue until
the clutch engages (clicking).
8. Reverse the direction of the drill to turn
counterclockwise and start the drill until the upper
position of the flaring cone is reached and the
clutch engages (clicking)
9. Loosen the tension rod.
10. Slide out flaring body towards the end and
open flaring bar.
OPERATING INSTRUCTIONS
(
MANUAL)
Flaring Bar
2. With the hex screws facing down on the flaring
bar, open the flaring bar and insert the flaring bar
into the flaring body where the arrow is pointed.
3. Once inserted pull forward and open the flaring
bar.
Tubing Depth
Stopper
Tubing
Tubing Size
Tension Rod
Flaring Yoke
Assembly
Flaring
Handle
03
02
Step 2
Step 3
4. Place the tubing depth stopper at the right size.
Insert copper tubing up to the tubing depth
stopper.
1. Make sure the flare handle is
properly installed
on the flare body.
Hex screws