BHM
01/08/15
NTV-DOC198
Agreement
:
End user agrees to use this product in compliance with all State and Federal laws. NAV-TV Corp. would not be held liable for
misuse of its product. If you do not agree, please discontinue use immediately and return product to place of purchase. This product is
intended for off-road use and passenger entertainment only.
4 |
P a g e
7.
Connect the AV Input cable to the port on the W221 interface labeled
‘AV IN/OUT’
. If
you’re only connecting a reverse camera (and no other
inputs), the signal input from the camera must connect
to the RCA labeled
‘REAR-C’
. Refer to the dip-
switch settings chart to skip/enable AV sources
upon toggle switch presses (optional. Page 2).
8.
Optional:
Connect the remote eye to the port labeled
‘IR’
and
leave it in clear view of the driver (often it can be stuck inside a
vent). This connection would be necessary if you want to be able
to adjust anything from the W221 interface’s menu.
a.
While in any AV mode other than factory
(on the display
screen), press the
MENU
button
for
Menu 1
,
or
hold the
left arrow
to enter
MENU 2.
b.
To switch between AV modes, press the
‘OK’
button.
9.
Optional:
Connect the provided momentary toggle switch to the
port on the W221 interface labeled
‘MODE’
. Pressing this switch with the ignition on will
cycle the screen modes as follows:
factory screen > NAVI
(RGB) > AV1 > AV2 > AV3 > factory screen
.
10.
Note:
All other included harnesses not mentioned in this manual are not needed for most
installations.
If you would like to know more about the full capability of this interface,
contact NAV-TV tech support at 561-955-9770. Additional features not mentioned in this
manual are not supported by NAV-TV at this time.
11.
Test the interface by placing the vehicle in reverse with the car running. The camera
signal supplied to the ‘REAR-C’ RCA should display on screen in reverse only.
