BHM
01/08/15
NTV-DOC198
Agreement
:
End user agrees to use this product in compliance with all State and Federal laws. NAV-TV Corp. would not be held liable for
misuse of its product. If you do not agree, please discontinue use immediately and return product to place of purchase. This product is
intended for off-road use and passenger entertainment only.
3 |
P a g e
Installation
1.
Remove the factory radio and screen. This normally requires removing trim panels and a
series of screws. Disconnect all harnesses connected to the radio / screen and set them
aside.
2.
From the provided
Power Harness
, locate and solder the following wires to the car:
3.
Connect the white 16-pin power connector to the port on the w221 interface labeled
‘
Power/CAN’
.
4.
Connect the provided
LVDS COMM Cable
between the W221 interface at the port
labeled
‘LVDS OUT’
and the provided
SUB-Board
. This connector is keyed, and
can only fit in one direction and one
port.
5.
Connect the factory LVDS Video cable (from the screen)
to the green LVDS port on the provided
SUB-Board:
6.
Connect the supplied
LVDS Video Cable
to
the 5-pin plug on the
SUB-Board
used
from step 9 and connect the other
end to the factory Mercedes screen at
the appropriate port.
W221-10 Wire Label
Connect to CAR’s
Location (suggestion)
GND (black)
Ground (-)
Cigarette lighter
ACC (red)
Accessory wire (+)
Cigarette lighter
REAR-C (gray)
12v (+) reverse wire
Reverse light
