BHM
10/18/18
NTV-DOC328
Agreement
:
End user agrees to use this product in compliance with all State and Federal laws. NAV-TV Corp. would not be held liable for misuse of its product.
If you do not agree, please discontinue use immediately and return product to place of purchase. This product is intended for off-road use and passenger
entertainment only.
6 |
P a g e
8.
Connect one end of the provided
LVDS Video Cable
to the port on the W205v2 interface labeled
‘
VIDEO-IN
’
.
9.
Connect the other end of the provided
LVDS Video
Cable
back to the factory radio at the
‘DISP’
(typically dark blue) port.
10.
Power your reverse camera with an accessory 12v source, or use the
purple
wire
for
reverse 12v only.
Splice ground (-) to the black wire provided to the interface, or find another ground point/wire in the
car.
11.
Connect signal from the rear camera to the
RCA labeled ‘CAMERA’ among the main Power/CAN
harness.
12.
Connect the white plug from the Power/CAN Harness to the port on the W205V2 RVC interface
labeled
‘P
OWER/CAN
’
.
13.
Optional:
If adding an additional video input (including front camera), use the provided RCA labeled
‘
AV IN
’ for signal input. This video source
must
be powered with an ACC source.
NOTE: If the user
desires for automatic front camera-switching, this option must be set upon installation. See MENU
Settings on page 8.
14.
Start the car and test for proper functionality before replacing any dash pieces.
NOTE:
If after verifying DIP Switches and you still don’t get reverse activation (screen switching to cam
-image
while in reverse), re-test with ALL dash-board pieces connected properly.
NOTE:
If (the above) was tried and the screen will still not switch, providing the
green wire
among the main
power harness
with a (+) reverse signal will switch the screen manually.