BHM
05/05/14
NTV-DOC187
Agreement
:
End user agrees to use this product in compliance with all State and Federal laws. NAV-TV Corp. would not be held liable for
misuse of its product. If you do not agree, please discontinue use immediately and return product to place of purchase. This product is
intended for off-road use and passenger entertainment only.
2 |
P a g e
Installation
1.
Remove the factory radio, disconnect all harnesses and set the radio aside.
2.
Install the provided camera into the trunk lid. Be certain to check for clearance before
drilling any holes using the provided hole-saw.
3.
Connect the provided
Camera Extension
to the camera and
run the RCA/power end forward to the dashboard opening.
4.
Connect the
black
and
red
wires from the CAM power harness to ground (-) and ACC
12v (+).
The radio must see the camera upon vehicle startup in order for the screen to
flip to the camera’s image when in reverse. You MUST connect the camera to an
accessory/ignition source and not a reverse light for proper operation!
Note: you can find ground (-)
and ACC 12v (+) at the radio’s
power harness (test!):
5.
Connect the supplied video t-harness in the connector shown here (below). It is keyed
and will only fit in one direction:
6.
Connect the camera’s
composite signal to
the RCA on the
provided
Video input
harness
, via the CAM
power harness.
7.
Reconnect all the harnesses to radio, reassemble the dash and test by starting the car
and placing it into reverse. The reverse image should activate automatically (whenever
in reverse).
If the radio does not transition in reverse and you’ve verified that the rest
Toyota Pin #
Description
Color
3
Accessory 12v (+)
Gray
7
Ground (-)
Brown
