JR, BM
05/17/2016
NTV-DOC105
2 |
P a g e
Agreement
:
End user agrees to use this product in compliance with all State and Federal laws. NAV-TV Corp. would not be held liable for
misuse of its product. If you do not agree, please discontinue use immediately and return product to place of purchase. This product is
intended for off-road use and passenger entertainment only.
SRX VIM Module pin outs
Pin #
Description
Color
1
12v (+) Constant
Yellow
2
INPUT 1 (Send 12v for VIM act)
Red
9
GM LAN (Radio side)
Green
10
Ground (-)
Black
11
Reverse OUT
White/Red
12
OUTPUT A (GPS Break)
White/Blue
13
OUTPUT B (ACC Out)
White/Purple
18
GM LAN (Car side)
Purple
Installation
Dash Disassembly
1.
Using a plastic pry tool, remove the carpeted side covers on either side of the center console.
2.
Once the side covers are removed, there will be (2x) 7mm screws on either side that hold the
vinyl trim panels in place. After the screws are removed gently pry up the trim on either side of
the console.
3.
With the trim panels removed, (2x) 10mm bolts will be exposed next to the pocket under the
radio. Remove these 2 bolts.
4.
Gently pry up the silver trim panel around the cup holder and shift plate. This will expose 4)
screws around the cup holder and 2) screws in front of the pocket under the radio. Remove
these screws.
5.
Open the center console lid. Using a pick tool, remove the (2x) rubber stops to the front of the
console pocket. Remove the (2x) screws.
6.
From the back seat, remove the rear HVAC panel and set to the side. There will be (3x) 10mm
nuts securing the lid to the console. Remove these 3 bolts.
7.
Remove the shifter knob by pulling down the silver ring attaching the boot to the shifter knob.
Using a pick tool, remove the C-clip holding the shifter in place. Pull off the shifter knob and set
to the side.
8.
Gently pry up the top of the center console/shifter plate. Detach any wiring and set aside.
9.
Remove the (2x) 7mm screws holding the pocket under the radio in place.
10.
Remove the pocket to expose (2x) 7mm screws securing the radio/HVAC trim in place.
11.
Turn on the radio and motorize the screen out of the dash. With the screen open, GENTLY with
two hands pull the vinyl cover off the screen. Turn off the radio and wait for the screen to
motorize down.
12.
Gently pry around the trim to remove. Disconnect the wiring and set aside.
13.
The DVD drive will have (4x) 7mm screws. Remove the drive, disconnect all connections and set
aside.
Wire Side
