BHM
10/09/15
NTV-DOC243
Agreement
:
End user agrees to use this product in compliance with all State and Federal laws. NAV-TV Corp. would not be held liable for
misuse of its product. If you do not agree, please discontinue use immediately and return product to place of purchase. This product is
intended for off-road use and passenger entertainment only.
5 |
P a g e
8.
Install your reverse camera and run signal, power and ground wires up front to the AUDI
interface.
9.
Power your camera with an ACC source, not a reverse lamp trigger (the
purple
wire
from the main power harness labeled
‘REAR12VOUT’
provides 12v (+) when in reverese
only, if you want to use a reverse signal).
10.
Connect the signal for your camera to the yellow RCA among the
Power/CAN Harness
labeled
‘CAMERA’
.
11.
Optional:
If adding an auxillary video in or front camera, connect the signal to the RCA
among the
Power/CAN Harness
labeled ‘CVBSIN’. If automatic front camera switching is
desired, the setting must be activated in the OSD Menu system. See page 8.
12.
Connect the 24-pin white plug from the
Power/CAN Harness
to the port on the AUDI 09
interface labeled
‘Power/CAN’
.
13.
UPDATE:
For older AUDI’s (only) that do
not
have the ‘iNAV’ button on the steering
wheel and adding AUX Video/Front Camera, connect (solder) the
White
wire
labeled
‘MMI’ to the
MMI
data wire located behind the OEM radio at the Euro-style plug, at
pin
10
. This wire color will vary by vehicle, but the
pin location
will remain the same.
Press the
NAV
button near the MMi command knob for switching to the AUX
video/front camera source at any time.
14.
Start the car and test for proper functionality before replacing dash pieces. If menu
adjustments are needed (to remove sensor overlay, etc.), proceed to ‘Menu
Adjustments’
Wire side view
