21
Disconnect all power to the machine before you service it.
Note:
Your machine may not match the image. For reference only.
1. Press the edges of the Console Pivot Shroud to disen-
gage the tabs from the Console. Remove the Console Pivot
Shroud and set it safely aside.
2. Remove screws that attach Console to the Mast. Care-
fully lift the Console off the Mast.
3. Disconnect the Data Cable, Heart Rate Cable and Re-
sistance Cable at the top of the Mast. Discard the Console
and screws.
Note:
Do not let the cables fall down inside the Mast. This
step may require two people.
4. Installation is the reverse procedure.
5. Discard the old parts.
6. Inspect your machine to ensure that all hardware is tight
and components are properly assembled.
Do not use until the machine has been fully
assembled and inspected for correct performance
in accordance with the Owner’s Manual.
Initial Setup
During the first power-up, the Console should be set up with the date,
time, your preferred measurement units and machine type.
1. Date: Push the Increase/Decrease buttons to adjust the currently active
value (flashing). Push the Left/Right buttons to change which segment is
the currently active value (month / day / year).
2. Push OK to set.
3. Time: Push the Increase/Decrease buttons to adjust the currently active
value (flashing). Push the Left/Right buttons to change which segment is
the currently active value (hour / minute / AM or PM).
4. Push OK to set.
5. Units of Measurement: Push the Increase/Decrease buttons to adjust
between “MILES” (Imperial English) or “KM” (metric).
6. Push OK to set.
7. The Console display shows the Machine Type prompt with the current
setting. This menu option appears in the x614 series console only (not the
x616 series consoles). Push the Increase/Decrease buttons to change
between “BIKE” and Elliptical (“ELIP”).
8. Push OK to set. The Console goes back to the Power-Up / Idle Mode
screen.
Note: To adjust these selections, consult the “Console Service
Mode” section.
