76
5. Using a #2 Phillips screwdriver, remove the two indicated screws (with
arrows) from the Deck Wheel Shroud.
6. Using a 13mm wrench and a 6mm hex wrench, remove the hardware
indicated from the Deck Wheel.
7. Re-install all parts that were removed in reverse order.
8. Make sure there is sufficient space to lower the walking deck.
Keep a minimum clearance behind the machine of 79” (2 m)
and 24” (0.6 m) on each side. This is the recommended safe
distance for access, movement and emergency dismounts
from the machine.
9. Make sure there is no object on or around the treadmill to spill or cause
blockage from the fully unfolded position.
10. Slightly push the walking deck forward toward the console, and then push the Deck Release Button until the locking tube releases and you can
pull the walking deck away from the console. Hold up the rear of the walking deck, and move to the side of the machine.
Keep clear of the movement path of the walking deck.
11. The hydraulic lift is set up to drop gradually. Hold onto the walking deck until approximately 2/3 of the movement down. Make sure that you use
proper lifting technique; bend your knees and keep your back straight. Be aware that the walking deck can possibly drop quickly in the last part of the
movement.
12. Final Inspection
Inspect your machine to ensure that all hardware is tight and components are properly assembled.
Do not use until the machine has been fully assembled and inspected for correct performance in accordance with the Owner’s
Manual.
