Nautilus Commercial Series TreadClimber TC916, Инструкция по сборке

Страница: 28 / 44

asseMbly InsTRUcTIons
step4:dismantlingcrate
Tools:
• hammer
4-1 Carefully dismantle the wooden crate to allow
access to the bottom half of the TreadClimber
®
TC916 frame.
noTe: The TreadClimber
®
TC916 base frame should
be close to the final location for the fully
assembled machine during this step.
step5:removingfromPallet
Tools:
• 7/16 socket
• ratchet
5-1 remove TC916 from pallet by removing
restraining stabilizer brackets with socket and
ratchet from stabilizer feet (see figure 1).
5-2 manually slide TC916 to one side of the pallet
- over hanging approximately 12 to 15 inches off
the side of the pallet (see figure 2).
5-3 Tilt unit to side and slide edge of frame to ground
(see figure 3).
5-4 Tilt to 40 degrees and move pallet out of the way,
lowering TC916 to ground.
noTe: When removing the TreadClimber
®
TC916
from pallet you should be placing the unit in its
final position in the facility.
figure 1
figure 2
figure 3
remove wooden supports
around base assembly.