Current as of 2021/11/11
2.
Align the "O" mark on the port with the WHITE dot on the
housing. Gently push the port towards the housing until it
cannot go any further.
3.
Lock the port into place by turning the port locking lever of the
housing to the inward position. To ensure that the port is securely
mounted, confirm that the green line on the safety button of the
port locking lever is visible.
1.
Make sure the focus knob is at its most outwards position
before mounting/unmounting the port. The knob should be left
at this position until it is made sure that the lens and focus gear
is properly installed.
2.
Engage the gear by pushing in the knob, then turn the knob
both ways to check if the lens focuses.
R
R
R
R
EMOVE THE
EMOVE THE
EMOVE THE
EMOVE THE FOCUS
FOCUS
FOCUS
FOCUS KNOB AND SEAL IT WITH PROVIDED PLUG
KNOB AND SEAL IT WITH PROVIDED PLUG
KNOB AND SEAL IT WITH PROVIDED PLUG
KNOB AND SEAL IT WITH PROVIDED PLUG
1.
Remove the internal gear by using the appropriate Allen
Key after removal of the screw.
2.
Take the gear and screw along with a c-ring out as shown
below.
3.
Followed by remove the screw cover and screw sets from
the focus knob plug (with a push pin or a sharp object).
4.
Gently pull out the whole focus knob set from the port, and
store the focus knob set along with the internal gear and
screws in a safe bag for future use.
E
E
E
E
NGAGE WITH
NGAGE WITH
NGAGE WITH
NGAGE WITH
LLLL
ENS GEAR
ENS GEAR
ENS GEAR
ENS GEAR
