MOUNT GEARS ON LENS
7. Align the inner groove of the macro
switch gear with the white dot on the
zoom gear tube. Then lightly push the
gear towards the lens until it cannot
go any further.
8. Tighten the macro switch gear by
screwing the locking ring into the
thread on the front of the lens.
9. Align the positioning block onto the
two gears. With the longer ends
inserted into the hole of the zoom gear
and the shorter ends sat into the
groove of the macro switch gear. Then
tighten the two screws. Repeat this
with the other two blocks and check if
the lens can be switched between
macro mode and normal mode by
turning the macro switch gear. Repeat
the above procedure if fail to switch
.
10. To un-mount, reverse the above steps.
*When mounting the Olympus 12-50mm EZ lens
with the gear on the GH5/EM1X camera, or
when removing them, the lens must be set to
the “Macro” position.
