
SCREW-IN SETTING CROWN
Some deep-depth water-resistant watches require the setting crown to
be screwed in to ensure water-resistancy.
If your Nautica watch has
a transparent sticker at back of the case back (diagram above)
please unscrew the crown before setting your watch, and the
crown must be screwed in after setting the watch.
To screw in, push in the crown firmly against the thread protrusion and
hold it in while turning the crown clockwise. Continue to screw in the
crown light until it is tight .
ATTENTION
This is a screw down crown
Do not pull
Please read instruction
booklet before operation
SCREW-IN SETTING CROWN STICKER
4
ElAPSED TIME RING
If your watch is equipped with a rotating outer dial with numbers and
indicators, this Elapsed Time Ring may be used to indicate the length
of time remaining for an activity or the starting time of an activity.
TIME REMAINING
- set the outer ring so that the triangle is pointing
to the time the activity is to end.
STARTING TIME
- set the triangle on the time the activity is to begin.
TACHyMETER
A tachymeter measures the speed at which the wearer has traveled
over a measured distance, i.e., a measured mile on the highway. For
example, start the chronograph when you pass the starting point and
stop it when you pass the finish point. You can then read your speed
in units per hour off the tachymeter scale.
BAND ADJUSTMENT
To disconnect band from clasp, press in end of spring bar
(use pin or small paper clip) and separate link band from
clasp as illustrated.
To reassemble band to clasp, place spring bar in band and place end of
spring bar into desired hole in clasp. Press opposite end of spring bar in
and slide into clasp and position so tip snaps into corresponding hole.
5