Fig.16
Fig.15
1
2
Trouble Shooting
1. Remove the SEASCOOTER™ from the water.
2. Make sure the master switch is off.
3. Remove the battery - see page 16, step 1-9.
Removing rear grille and Propeller to remove obstruction
9. Replace the washer(s) and nut and tighten with the socket
while holding the Propeller making sure it is securely
fastened (See figure 20).
10. Replace the grille.
11. Replace the battery.
6. Slide the Propeller off the shaft, taking care not to loose the
drive pin or washers.
7. Remove the blockage from the Propeller.
8. Replace the drive pin (if removed), see figure 19, and Propeller.
Turn the Propeller slowly until you locate the pin and push
the Propeller fully on.
Unit does not function
If the motor does not start when both triggers are pressed,
make sure
1. The battery is properly connected.
2. The battery is fully charged.
(see page 16, charging the battery)
3. The master switch is in the "On" position.
(see fig 3, page 8)
4. There is no water in the battery compartment.
(see page 28, accidental flooding)
Blocked Propeller
If the Propeller becomes blocked first try and remove the
obstruction by removing the front grille. If this is not
possible the back grille and Propeller can be removed.
Under normal use the grilles must not be removed.
Removing the front grille to remove an obstruction.
1. Remove the SEASCOOTER
™
from the water.
2. Make sure the master switch is in the Off position.
3. Insert a screw driver as shown in figure 15 (page 25) to
remove the two grille pins.
4. Unclip grille as shown in figure 16 (page 25) .
5. Remove obstruction.
6. Reassemble grille and insert clips.
25
24
4. Unscrew the six rear grille screws as shown in figure 17.
5. While holding the Propeller, use an M6 socket to remove the
nut from the Propeller shaft (See figure 18).
Crushing / Cutting Hazard
Before opening the grille for maintenance purpose,
make sure the master switch is in off position, and
the battery is disconnected.
WARNING
