NAUTICA MARINE 200, Руководство пользователя

Страница: 14 / 19

Waterhousing Thumb Screw
Care and Maintenance CAMERA ASSEMBLY
Battery Care
• Please read and understand important Battery Use
safety information on pages 12 to 15.
• The battery supplied with your SEASCOOTER
™
should
last about 200 cycles or two years before it should be
replaced. Please contact your local customer service
centre/distributor. Using a battery in excess of these
recommendations can result in excessive off-gassing of
hazardous gases .
• ALWAYS remove the battery from the SEASCOOTER
™
immediately after use.
• DO NOT STORE BATTERY IN SEASCOOTER
™
Care after using the SEASCOOTER
™
• DO NOT leave the Seascooter in the water. Always take
the unit out of water when not in use.
• Always rinse the SEASCOOTER
™
in fresh water and
allow it to dry before storage immediately after use.
• To clean the SEASCOOTER
™
do not use detergents,
only use a damp cloth to wipe the unit clean.
• The Battery Housing interior should be kept dry at
all times.
• If the Battery Housing interior ever gets wet,
see page 28, Accidental Flooding for procedure.
• When storing the SEASCOOTER
™
for extended periods
of time, open the Vent Plug in the Inner Nose Cone.
• ALWAYS store your SEASCOOTER
™
vertically when not
in use to prevent deformation of the Propeller Nozzle.
1. Remove the SEASCOOTER™ from the water.
2. Make sure the master switch is off.
3. Remove the battery - see page 16, step 1-9.
9. Replace the washer(s) and nut and tighten with the socket
while holding the Propeller making sure it is securely
fastened (See figure 20).
10. Replace the grille.
11. Replace the battery.
6. Slide the Propeller off the shaft, taking care not to loose the
drive pin or washers.
7. Remove the blockage from the Propeller.
8. Replace the drive pin (if removed), see figure 19, and Propeller.
Turn the Propeller slowly until you locate the pin and push
the Propeller fully on.
22 23
4. Unscrew the six rear grille screws as shown in figure 17.
5. While holding the Propeller, use an M6 socket to remove the
nut from the Propeller shaft (See figure 18).
*
Camera and Screw are not included
Insert and Tighten Up
the Thumb Screw
Simply attach the Camera
to the mount and align the hole
To attach your camera to Seascooter, you will need a thumb
screw or hardware depending on the mount you are using.
ATTACHING YOUR CAMERA TO SEASCOOTER MOUNTS
(Can be used with GoPro
®
HERO [3, 3+, 4, 5, 6 or 7] cameras,
or other camera with using the same mount system)