Nautic Alert VTracker, Инструкция по эксплуатации

Страница: 12 / 26

Page 12
Mode/Set Buttons and Zone Configuration Settings
VTracker contains two zone inputs, which can be configured as follows by using the “Mode” and “Set”
button interface:
- SWITCH- Toggles the switch output between On and Off
- ALARM 1- Toggles between Zone Normally Open, Zone Normally Closed, SOS, and geofence
arm/disarm control (indicated by both the “Zone” and “SOS” LEDs being active)
- ALARM 1 ACTIVE - Resets the alarm if it has been latched
o
Setting is only accessible if the alarm has been latched
- ALARM 2- Toggles between Zone Normally Open, Zone Normally Closed, and Water (high water
float)
- ALARM 2 ACTIVE- Resets the alarm if it has been latched
o
Setting is only accessible if the alarm has been latched
- RESET DEFAULTS- Resets defaults for switch output, alarm input types, and latched alarm states
o
Setting this takes about 30 seconds to complete, followed by a system reset
Configuring and Testing Zones
When configuring and testing zones, it is recommended to disconnect the antenna first to prevent
against any accidental notifications, especially SOS events, unless live testing is desired. Monthly live
testing is recommended, and third parties receiving notifications should be notified in advance and in
accordance with 3
rd
party monitoring agreements.
If using a “Zone” alarm type, opening and closing the connected sensor/button/switch will update the
corresponding zone’s “Active” LED, if the system is disarmed. The system can be forced into a disarmed
state by resetting defaults.