Nautel VX150, Руководство по установке

Страница: 39 / 86

VX150 TO VX2 INSTALLATION MANUAL PROGRAM INPUTS
VERSION 0.3 2021-01-14 PAGE 1.7.1
SECTION 1.7: PROGRAM INPUTS
The VX series transmitter accepts a variety of analog and digital program inputs. This section describes
the requirements associated with the audio feeds to the transmitter. All connections are made at the
rear of the transmitter (see
Figure 1.7.1: on page 1.7.5 ). Where D-sub connectors are used as the
interface, Nautel provides associated mating connectors in the ancillary parts kit to facilitate customer
connections.
NOTE
:
This section provides the information required to determine your program inputs and plan for
their connection to the transmitter. Physical connections are made in
Section 1.10, “Completing External
Connections” on page 1.10.1
.
 Analog Inputs
 Left and Right Inputs - see page 1.7.1
 MPX/SCA Inputs - see page 1.7.2
 Digital Inputs - see page 1.7.2
 AES/EBU Inputs - see page 1.7.2
 RBDS/RDS Input - see page 1.7.2
 Other Features - see page 1.7.2
 Carrier Frequency and Pilot Phase Control (10 MHz and 1 PPS IN) - see page 1.7.2
 Pilot/MPX Sample - see page 1.7.3
 External Audio Playlist via USB - see page 1.7.3
Analog Inputs
Each VX series transmitter exciter accepts the following analog inputs:
Left and Right Inputs
Balanced analog left/right or monaural input (left only) (30 Hz to 15 kHz, -12 to +12 dBu) can be
applied to
ANALOG AUDIO IN,
3-pin female XLR connectors. The VX series transmitter’s remote AUI or
front panel UI allows for configuration of the audio input mode (left, right or stereo). Provision is made
for adjustment of the input sensitivity and pre-emphasis, adjustable between -12 and +12 dBu.
The
input impedance for each input is 600

.