Nautel Exporter Plus, Техническое руководство по эксплуатации, Страница: 55 / 186

Exporter Plus Technical Instruction Manual Remote interfacing
Issue 1.0 2020-05-05 Page 7-3
Network based control - Ethernet interface
All user interface functions on the Exporter Plus front panel are available through an Ethernet
remote interface feature. This interface basically duplicates the front panel display using a text-
based display on a PC.
Set up the Ethernet interface as follows:
1. Log on to a PC on a network that can access the Exporter Plus. See Figure 1.5 on page
1-4 or Figure 1.6 on page 1-5 for examples.
2. From the
Start
menu on your PC’s Windows desktop, select
Run... ,
enter
cmd
in the
Open:
field and click
OK
(see Figure 7.1 ).
Figure 7.1: Windows Run Command
3. At the command prompt enter
telnet xxx.xxx.xxx.xxx 2323 -t vt100
(see Figure 7.2
on page 7-4 ). Note that:
xxx.xxx.xxx.xxx
is the IP address of the Exporter Plus.
2323
is the Ethernet port number for the application.
-t vt100
sets the terminal emulation type.
Note: Telnet (Telecommunication network) protocol is used as the basis for this type of
interface. Telnet may be interfaced from any Terminal Emulation application that
supports TCP/IP protocol and VT100 or XTerm emulation.