Switching off MADSEN Astera²
1. To switch off MADSEN Astera², disconnect the power supply from the mains outlet.
6
Connecting MADSEN Astera² to Otosuite
When you use MADSEN Astera² for the first time, run the Configuration Wizard to set up the connection between
MADSEN Astera² and Otosuite. After you have configured Otosuite for the first time, if MADSEN Astera² is turned on when
you open the Control Panel in Otosuite, then MADSEN Astera² will connect to Otosuite automatically. Otherwise, you can
connect MADSEN Astera² as follows:
1. Switch on the device.
2. Launch Otosuite.
3. In the Otosuite toolbar, click
Control Panel
(Control Panel).
4. In the Control Panel, click
Connect
(Connect).
7
On-screen controls
Test controls provide a means of operating the audiometer if you use the mouse and on-screen options to perform tests.
•
To enable test controls, select
Tools
>
Options
>
Audiometry
>
General
>
On-screen controls
>
Show
>
On
(Tools >
Options > Audiometry > General > On-screen controls > Show > On).
Silence Mode
Silence Mode allows you to control tone levels and presentation by hovering the mouse cursor over the respective on-
screen controls. This is particularly useful when the operator of the audiometer and the person being tested are in the
same room.
•
To enable silence mode, select
Tools
>
Options
>
Audiometry
>
General
>
On-screen controls
>
Silence Mode
>
On
(Tools > Options > Audiometry > General > On-screen controls > Silence Mode > On).
•
To change the level and frequency by more than one click at a time, use the mouse scroll wheel.
12
MADSEN Astera²
6 Connecting MADSEN Astera² to Otosuite
