natus Dantec Keypoint G4, Инструкции по эксплуатации оборудования

Страница: 15 / 42

Hardware Instructions for Use
15
Cable Connections
Before operating the device, the system parts should be connected.
1. Connect all the signal interface cables as depicted in the illustration (black thin).
2. Connect all the power interface cables as depicted in the illustration, except for the main
cables to the wall outlet (blue dotted).
3. Check voltage:
- On the Power Supply unit, make sure that the voltage selectors are set to the proper
voltage settings.
- On the Isolating Transformer unit, make sure that the correct voltage type is used.
4. Connect the mains cable to the wall outlet (blue dotted).
5. Press the Power on/off button on the front panel of the computer for the system to turn on.
CAUTION Use only optional devices specified by Natus in order to comply with IEC 60601-1.
CAUTION Always use shielded power line cables from Natus to avoid hum line interference,
especially near the patient, or the amplifier.
NOTE Unplugging the power line cable from the mains input on the power supply/Isolating
Transformer disconnects the mains power of the complete system.
NOTE Make sure the device connected to the wall power outlet is positioned in such a way to allow
easy disconnection from the mains, if needed.
NOTE HS LINK – Multiple types of modules can be connected to HS LINK (see G, H, and O in the
figure above). Certain types of module combinations are restricted due to HS LINK power limit. Module
restrictions are software controlled.
NOTE HS LINK – Modules (G, H, and O) connected to HS LINK may have certain limitations due
to system power consumption conditions. Limitations are hardware related and can be avoided by
using the DC Power Supply (N).