ASSEMBLY
Lamp Assembly
1. (SEE FIGURE 1) Insert the LED circuit wires of the lantern assembly (A) though the center of the lock
spring (K) and lantern top (B). Thread the lantern top (B) to the assembly (A) and secure the top by
turning clockwise to tighten.
2. Connect the LED circuit wires (input wires) found on the top of the lantern body (C) to the LED circuit
wires (output wires) found on the bottom of the lantern top covers of the lantern assembly (A).
3. Attach the lantern body (C) to the lantern top cover on the lantern assembly (A) and using small screws
(L) two places.
Repeat with the other 2 lantern bodies (C).
Figure 1
Planter Base Assembly
Note: If using ground mounting instead of planter base mounting refer to “Ground Mounting”
1. (SEE FIGURE 2) Attach lamp post base (D) to bottom planter base (I) using hex bolts (N), mounting
plate (S),flat washer (Q), and hex nut(O).Make sure the mounting plate, flat washer and hex nut are
secured to the hex bolt on the underside of the bottom of planter base (I).
2.
(SEE FIGURE 3)
Attach the top planter base (H) to the bottom planter base (I) by lining up the 4 tabs
and pulling the top planter base up until tabs snap into place. Turn clockwise to lock the tabs into place.
Note: If may be necessary to put pressure on the bottom planter base when pulling the top planter base
up.
Figure 2 Figure 3
