10
11
USE
CLEANING AND DESCALING
1. DESCRIPTION
2. SPECIFICATIONS
3. DESCRIPTION OF THE BUTTONS
Fill the kettle with water to the maximum level before first use, boil it once, then
empty out the boiling water and rinse out the kettle.
This product consists of a clear-glass teapot slotted into a rectangular base where
it turns 360°.
When you start the product, all the LEDs will light up for 1 second upon being
powered. When the beep sounds, all the LEDs will go out again.
1. ON/OFF button:
press this button to switch on the teapot. If the teapot is not
on the base, the display will show « 0 » and light up. You will hear a beep every 3
seconds. The display will turn itself off if no function has been selected after 90
seconds. If the teapot is slotted into the base properly, the display will show « 0 ».
If no function has been selected after 30 seconds, the display will turn itself off.
Press the « ON/OFF » button again to switch the teapot off.
Before cleaning the appliance, turn it off, unplug it, and wait until it has cooled.
• Wipe down the external surfaces and the base with a damp cloth. Dry it well.
• Clean the inside of the kettle with a sponge and hot soapy water. If you can’t
fit your hand through the opening of the lid, fill the kettle with hot soapy water,
close the lid and shake it. Then rinse out the interior well to remove all of the
soapy water.
• Never use chemical or abrasive cleaning products.
• Never submerge the kettle or the base in water.
• The kettle must be descaled regularly using a specific descaling product.
Model No.
Voltage
Frequency
Power
Volume
AEK-608
220~240V~
50/60Hz
800W
1.0L
Power
Time to have boil water (100 °C)
20 to 50 W
Keep warm only
100 W
About 1 hour
300 W
About 20min
500 W
About 12min
800W
About 6min
2. Function button:
press this button to select a function when the teapot is switched
on. The function indicator will move from left to right every time you press the
button.
3. Regulate button (power/temperature):
Power:
select the « Power » function, then press the « Regulate » button to adjust
the power across a range of 20 to 800 W using the following increments: 20 W,
50 W, 100 W, 300 W, 500 W and 800 W.
4. Time/Delay button:
In ON mode, press this button to pre-program your teapot. You
can program your drink between 30 minutes (0:30) and 12 hours (12:00) in advance.
Each press of the « Time/Delay » button increases the delay by 30 minutes.
Press the « Time/Delay » button as many times as necessary, then press the
« Function » button to select the program you which to pre-set (fast boil, black
tea, infusion, etc.).
If you do not select a program, the set time will be cancelled, the display will
flash five times and the teapot will go into standby mode.
If you have selected the delay and the program you want, the display will show
a countdown. When the countdown has finished and your drink is ready, you
will hear a beep.
Temperature:
select « Thermostat », then press the «Regulate» button to adjust the
temperature. It can be adjusted across a range of 45 to 100°C, with each press of
the button representing an increase of 5 degrees.