National Semiconductor INA260, Руководство пользователя

Страница: 8 / 32

INA260EVM
PCB
POWER
GND
V
SUPPLY
ALERT
SDA
SCL
SM-USB-DIG
Controller
T2
T1
I
LOAD
LOAD
GND
POWER
USB DATA
V
BUS
11.1 A
6.02 V
66.82 W
I
LOAD
V
BUS
P
LOAD
INA260EVM GUI
Overview
www.ti.com
8 SBOU180 – November 2016
Submit Documentation Feedback
Copyright © 2016, Texas Instruments Incorporated
INA260EVM-PDK and Software Tutorial
1.3 Related Documentation from Texas Instruments
The following documents provide information regarding Texas Instruments' integrated circuits used in the
assembly of the INA260EVM. This user's guide is available from the TI web site under literature number
SBOU180 . Any letter appended to the literature number corresponds to the document revision that is
current at the time of the writing of this document. Newer revisions may be available from the TI web site ,
or call the Texas Instruments' Literature Response Center at (800) 477-8924 or the Product Information
Center at (972) 644-5580. When ordering, identify the document by both title and literature number.
Table 2. Related Documentation
Document Literature Number
INA260 product data sheet SBOS656
SM-USB-DIG platform user guide SBOU098
2 INA260EVM-PDK Hardware
Figure 3 shows the overall system setup for the INA260EVM-PDK. The power source to be monitored is
connected to the EVM input terminals. The computer runs the GUI software through which the user can
enable power to the INA260 and communicate with the device. User commands are sent through the
computer's USB port to the SM-USB-DIG board that translates these commands into I
2
C format, before
sending them to the EVM. With power enabled, the INA260 responds to these I
2
C commands by sending
the requested data back to the SM-USB-DIG board over the I
2
C. The SM-USB-DIG converts the received
data to USB format and sends the data back to the computer, where it is then appropriately processed
and displayed to the user.
Figure 3. INA260EVM-PDK Hardware Setup