5
http://www.national.com
3.2 Computer Mode
Refer to
Figure 1
for locations of test points and
major components. The board comes configured
for “plug-and-play” WaveVision evaluation.
1. Run the WaveVision 4 program, version 4.4 or
higher is required to interface to the WV4
board. While the program is loading, continue
below.
2. Connect a USB cable between the WV4 board
and the PC running the WaveVision 4
software.
3.
Make the following required jumper
connections, see
Table 1
for more details:
•
JP9
- pins 1 & 2
•
JP7
- pins 2 & 3
•
JP6
- pins 1 & 2
•
JP8
- pins 1 & 2
•
JP10
- pins 1 & 2
4. Connect the
J1
header on the
DAC121C08XEB evaluation board to the WV4
serial connector (
J7
) on the WV4 board.
Refer to
Figure 3
for the serial connection and
Figure 4
for the J1 header pin out.
Note
: J1 on the DAC121C08XEB is
intentionally stuffed on the bottom side of the
board.
Figure 3: WV4 to DAC121C08XEB Connection
Figure 4: J1 (WV4S) Header
5. Perform step 7 of section 3.1 to configure the
loading of the analog output (V
OUT
).
6. Perform step 8 of section 3.1 to configure the
I
2
C slave address of the DAC.
7. Connect a clean (not switching) +5.0V power
source with a 350mA current limit to power
connector
J1
on the WV4 board. Turn on the
power supply.
8. Refer to
Section 5.0
on Software Operation
and Settings to setup the WaveVision 4
software.
J1
WV4S
SDA
(DAC)
1
3
5
7
9
11
13
2
4
6
8
10
12
14
GND
N/C
SDA
(EEPROM)
+3.3V
SCL
(EEPROM)
GND
+5V
N/C
SCL
(DAC)
Содержание DAC121C085
Страница 13: ...13 http www national com Blank Page...
