•
Check to see that the DUT input signal does not go
below ground or above the DUT analog supply
voltage.
•
Be sure that a minimum of +2.7V is at pin 1 of TP1.
•
Be sure that only one clock source (oscillator at Y1
or signal at BNC3) is active on the board.
6.0 Evaluation Board Specifications
Board Size:
3.1" x 3.8" (8.0 cm x 9.6 cm)
Power Requirements:
+ 5.5V to 5.7 @ 15 mA
Clock Frequency Range:
1 MHz to 20 MHz
Analog Input
Nominal Voltage:
Supply peak-to-peak Voltage
Impedance:
50 Ohms
7
http://www.national.com
