![background image](http://html1.mh-extra.com/html/national-instruments/vxipc-871b/vxipc-871b_user-manual_709824024.webp)
Chapter 3
Configuration and Default Settings
3-2
www.ni.com
Table 3-1 lists the factory-default settings and options for the onboard
jumpers and switches.
Note
Please do not adjust any jumpers or switches not listed in Table 3-1 or that are not
documented in this manual unless directed by National Instruments. Other configuration
jumpers are shown in the event National Instruments Technical Support needs to make
adjustments to your settings.
Software Default Settings
In this section, Tables 3-2 through 3-4 contain summaries of default
settings for VXIpc T&M Explorer. Because you can also use T&M Explorer
Table 3-1.
VXIpc 870 Series Hardware Default Settings
Jumper
Default Setting
Optional Setting
J12
Enable automatic Slot 0
detection
Force Slot 0;
Force Non-Slot 0
S1
MITE user configuration
MITE factory configuration
S2
Enable MITE
self-configuration
Disable MITE
self-configuration
W1,3,5,7
CPU bus factor
Note:
Refer to
section later in this
chapter.
W4
100 MHz CPU bus speed
66 MHz CPU bus speed
W6
Normal CMOS operation
Clear CMOS
W8
Flash write enable
Flash protection
W10
Enable Ethernet Serial
EEPROM configuration
Disable Ethernet Serial
EEPROM configuration
(uses default power on
values)
W11-12
Enable 16-bit SCSI
termination
SCSI termination
W15
Voltage monitor
only required voltages
Voltage monitor
all voltages