70
|
ni.com
|
NI VirtualBench Calibration Procedure
4.
Call
PS Get Adjustment Points
with the following parameter:
•
Channel
=
ps/+6V
This will return an array:
•
Adjustment Points
—An array of current points used in the adjustment steps
5.
Call
PS Set Adjustment Point
with the following parameters:
•
Channel
=
ps/+6V
•
Adjustment Point
—Supplied from the output of PS Get Adjustment Points
6.
Wait for the DC power supply to settle. The VB-8012 requires at least 60 seconds of settling
time. The VB-8034/8054 requires at least 5 seconds of settling time.
7.
Measure the output current with the DMM.
8.
Call
PS Measure Adjustment Point
with the following parameters:
•
Channel
=
ps/+6V
•
Reference Value
—Supplied from the DMM measurement in step 7
9.
Repeat steps 5 through 8 for each adjustment point on this channel.