Chapter 2
System Setup
©
National Instruments Corporation
2-3
TPC-2006 User Manual
2.
Connect the power connector to 24 VDC power lines. Be sure
to connect the positive, negative, and ground lines as shown in
Figure 2-1. The power lines can be from either a power adapter
or in-house power source.
Figure 2-1.
Power Connector
3.
Connect the power connector to the power receptor on the TPC-2006.
The power receptor pin assignment is shown in Figure 2-2.
Figure 2-2.
Power Receptor and Pin Assignment
4.
Power on the system.
Touchscreen Calibration
The TPC-2006 touchscreen should be correctly calibrated and ready to use
when you power on the system. However, if the calibration is not correct or
you want to choose custom calibration options, refer to the
Touchscreen
Calibration
section of Chapter 3,
System Configuration
.
+
–
GND
GND
–
+
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
