2.
Disassemble the TB-4162.
a)
Unscrew the three screws on the top of the TB-4162 to remove the top cover.
b)
Unscrew the two screws securing the strain relief to remove the strain relief.
Figure 1. Disassembled TB-4162
3.
Connect the signal wires and ground wire.
a)
Insert the stripped end of the ground wire into the LO screw terminal and tighten the
screw of the screw terminal to a torque of 0.5 Nm (4 lb · in.).
b)
Insert the stripped end of the signal wires into the appropriate terminals and tighten
the screws of the screw terminals to a torque of 0.5 Nm (4 lb · in.).
Refer to the following pinout, signal information, and PXIe-4162 pin map to make
the appropriate connections for your application.
TB-4162 User Guide
|
© National Instruments
|
3
