©
National Instruments Corporation
7
SCXI-1351 One-Slot Cable Extender
Installing the SCXI-1351 with a 100-Pin DIO Device in Serial Mode
Perform the following steps to install the SCXI-1351 with a 100-pin DIO
device in serial mode:
1.
Power off the computer and SCXI chassis.
2.
Install the SCXI module, following the instructions in the module user
manual.
3.
Connect the male breakout connector of the SCXI-1351 to the
appropriate 50-pin cable connector.
4.
Plug the mounting bracket connector of the SCXI-1351 into the
module rear signal connector. Make sure the alignment tab on the
bracket enters the upper device guide of the chassis.
5.
Screw the mounting bracket to the threaded strips in the rear of the
chassis to secure the SCXI-1351 in place.
6.
Connect the 100-pin cable connector to the DIO device.
Note
Leave the female rear connector without a connection.
Installing the SCXI-1351 with a 100-Pin DIO Device in Parallel Mode
Perform the following steps to install the SCXI-1351 with a 100-pin DIO
device in parallel mode:
1.
Power off the computer and SCXI chassis.
2.
Install the two SCXI modules, following the instructions in the module
user manual.
3.
Connect the male breakout connector of the SCXI-1351 to a 50-pin
cable connector. Connect the male breakout connector of another
SCXI-1351 to the other 50-pin cable connector.
4.
Plug the mounting bracket connector of each SCXI-1351 into the rear
signal connector of each module. Make sure the alignment tab on the
brackets enter the upper device guide of the chassis.
5.
Screw the mounting brackets to the threaded strips in the rear of the
chassis to secure the SCXI-1351 one-slot cable extenders in place.
6.
Connect the 100-pin cable connector to the DIO device.
Note
Leave the female rear connector without a connection.
