National Instruments SCXI 1346, Руководство по установке

Страница: 15 / 19

© National Instruments Corporation 15 SCXI-1346 Shielded Multichassis Cable Adapter
10. Click Finish . The SCXI chassis that was added is listed under Devices
and Interfaces .
11. Right-click the name of the SCXI chassis that was added, and choose
Test from the menu. The following dialog box should appear.
Figure 14. Successful Test Window
Note If the dialog box shown above does not appear, refer to the National Instruments
website
ni.com/support
for troubleshooting tips.
12. Repeat steps 3 through 11 until every SCXI chassis in the system is
shown under Devices and Interfaces .
Configuring a Multi-Chassis SCXI System
with a PXI-1010 or PXI-1011 Chassis
When you use an external SCXI chassis with a PXI-1010 or PXI-1011
combination chassis, cable the SCXI chassis directly to the 68-pin
connector located on the front of the PXI DAQ device that controls the
internal SCXI chassis as shown in Figure 15. If you are using more than one
external SCXI chassis, daisy-chain the SCXI chassis as shown in Figure 15
and configure them as outlined in
Configuring the Multi-Chassis SCXI
System with the following exceptions:
• PXI-1010/SCXI systems—Set the internal and external SCXI chassis
ID and address in ascending order starting with the internal SCXI
chassis and ending with the last external SCXI chassis (contains the
SCXI-1349 cable adapter).
• PXI-1011/SCXI systems—The default setting of the internal SCXI
chassis address is 0. Set the external SCXI chassis address(es) in
ascending order starting with 1. The last external SCXI chassis
(contains the SCXI-1349 adapter) has the highest address.