4
|
ni.com
|
SCB-19 User Guide
Tip
You can neaten the wires and provide mechanical support by sliding a cable tie
through one of the slots shown in Figure 2, wrapping the cable tie around the wires,
and tightening the cable tie.
4.
Close the top cover and tighten the four cover screws.
Caution
Refer to your device documentation for maximum voltage specifications.
Using voltages outside of the specified range could damage the SCB-19 and any
devices connected to it. NI is
not
liable for any damage resulting from using voltages
outside of the recommended range.
5.
Connect the SCB-19 to the AUX I/O front panel connector on your NI device using an
SHH19–H19–AUX cable (NI part number 152629-0
x
) and tighten the target screw, as
shown in Figure 3.
Figure 3.
SCB-19 Cable Connection
Caution
Although the AUX I/O front panel connector accepts a standard HDMI
cable, a standard HDMI cable causes significant crosstalk between some channels.
Use the SHH19–H19–AUX cable to minimize crosstalk.
When you have finished using the SCB-19, power off any external signals connected to the
SCB-19 before you power off your computer.
1
SCB-19
2
Target Screw
3
SHH19–H19–AUX Cable Assembly
1
2
3
