B-26
|
ni.com
Appendix B
Hardware Configuration
Hard Drive Part Numbers
Use the part number in Table B-46 to order a spare/upgrade hard drive.
PCI Expansion Card Installation
The system includes a pre-installed riser card that positions a standard size PCI-E x16 card at a
90 degree angle, allowing it to fit inside the chassis.
Installing PCI Expansion Cards
The CSE-RR1U-E16 riser card has already been pre-installed into the motherboard. Perform the
following steps to install an add-on card:
Begin by removing power from the system.
1.
Remove the chassis cover to access the inside of the system.
2.
Remove the PCI slot shield on the chassis by releasing the locking tab.
3.
Insert the expansion (add-on) card into the riser card.
4.
Secure the card with the locking tab.
Motherboard Battery
The motherboard uses non-volatile memory to retain system information when system power is
removed. This memory is powered by a lithium battery residing on the motherboard.
Replacing the Battery
Begin by removing power from the system.
1.
Push aside the small clamp that covers the edge of the battery. When the battery is released,
lift it out of the holder.
2.
To insert a new battery, slide one edge under the lip of the holder with the positive (+) side
facing up. Then push the other side down until the clamp snaps over it.
Note
Please handle used batteries carefully. Do not damage the battery in any way;
a damaged battery may release hazardous materials into the environment. Do
not
discard a used battery in the garbage or a public landfill. Please comply with the
regulations set up by your local hazardous waste management agency to dispose of
your used battery properly.
Table B-46.
Hard Drive Part Numbers
Part Number
Description
785651-01
Spare 1 TB HDD for RMC-8356
