Getting Started with R Series Intelligent DAQ
12
ni.com
9.
On the front panel, locate the numeric control labeled
AO Voltage
. Right-click the control and
select
Num Ctrls»Knob
from the
Express
controls palette to change the control type to knob.
10. On the front panel, click and highlight the value in the lower limit of the knob to change the limit
to –
32000
. Click and highlight the value in the upper limit to change the limit to
32000
.
11. Save the VI.
12. Using the terminal block, connect analog output channel 0 to analog input channel 0
by wiring AI0+ (RMIO pin 68) to AO0 (RMIO pin 55) and AI0– (RMIO pin 34) to
AOGND0 (RMIO pin 21), respectively.
13. Click the
Run
button in
Analog Input (Host).vi
and adjust the knob which controls analog output
channel 0. Notice how the change in voltage affects the reading on analog input channel 0.
Where to Go From Here
The following resources contain information for writing applications and taking measurements with
R Series Intelligent DAQ devices.
•
LabVIEW FPGA documentation
–
Getting Started with LabVIEW FPGA 8.x
—This KnowledgeBase, available at
ni.com/kb
,
provides links to the top resources that can be used to assist in getting started with
programming in LabVIEW FPGA.
–
FPGA Module
book in the
LabVIEW Help
—Select
Help»Search the LabVIEW Help
in
LabVIEW to view the
LabVIEW Help
. Browse the
FPGA Module
book in the
Contents
tab
for information about how to use the FPGA Module to create VIs that run on the NI 78
xx
R
device.
–
LabVIEW FPGA Module Release and Upgrade Notes—
Contains information about installing
the LabVIEW FPGA Module, describes new features, and provides upgrade information.
To access this document, refer to
ni.com/manuals
. In LabVIEW 8.0 or later, you can
also view the LabVIEW Manuals directory that contains this document by selecting
Start»
All Programs»National Instruments»LabVIEW»LabVIEW Manuals
.
