National Instruments PXIe-8238, Начало работы

Страница: 5 / 9

Caution
To protect both yourself and the chassis from electrical
hazards, leave the chassis off until you finish installing the
PXIe-8238.
2. Remove or open any doors or covers blocking access to the slot in which you
intend to install the PXIe-8238.
3. Touch a metal part of the chassis to discharge any static electricity that might
be on your clothes or body.
4. Make sure the injector/ejector handle is in its downward position. Be sure to
remove all connector packaging and protective caps from retaining screws on
the module.
5. Identify the slot in which the PXIe-8238 will be installed in the chassis. Refer to
the following table to determine which slot types the PXIe-8238 is compatible
with.
NI PXI Express Product PXI Express Chassis
Controller Peripheral Hybrid
H
PXIe-8238 — ✓ ✓
Table 1. PXIe-8238 Slot Type Compatibility
6. Align the PXIe-8238 with the card guides on the top and bottom of the slot.
Hold the handle as you slowly slide the module into the chassis until the
handle catches on the injector/ejector rail.
Caution
Do not raise the injector/ejector handle as you insert the
PXIe-8238. It will not insert properly unless the handle is in its
downward position so that it does not interfere with the injector/
ejector rail on the chassis.
7. Raise the injector/ejector handle until the module firmly seats into the
backplane receptacle connectors. The front panel of the PXIe-8238 should be
even with the front panel of the chassis.
8. Tighten the bracket-retaining screws on the top and bottom of the front panel
to secure the PXIe-8238 to the chassis.
9. Replace or close any doors or covers to the chassis.
© National Instruments
5
PXIe-8238 Getting Started