Model FRS2020
19” Rack Mount Chassis
with Dual Power Supply System
Installation and
Operation Manual
NITEK
®
De Schans 19-21 2a
8231 KA Lelystad
Tel: +31(0)320-230005
E-mail: [email protected]
WWW.NITEK.NL
USA
5410 Newport Drive, # 24
Rolling Meadows, IL 60008
Phone: (847) 259-8900
Fax: (847) 259-1300
E-mail: [email protected]
WWW.NITEK.NET
EUROPE
09172013
680160112
Reduce risk of fire or electrical shock. Do not
expose this product to rain or moisture.
Note: This installation should be made by a qualified
service person and conform with local codes.
Safety
The FSS20111S uses a Class 1 laser system in accordance with IEC 60825-1.
It is always advisable to follow good practice when working with optical fiber systems. This includes:
• Do not stare with unprotected eyes at fiber ends or connector faces.
• Use only approved filtered or attenuating viewing devices.
• For other safety issues and advice on good practices associated with optical fiber systems see IEC 60825-1 or your
local safety officer
.
Front View
The FRS2020 can be either rack mounted, or resting on a desktop.
NOTES:
1. Use all four mounting screws to properly secure the unit to the rack.
2.
Mechanical loading - The mounting ears were designed for two ears to support one unit.
3. Air-Flow - Leave space on the rear of the unit for airflow into cooling fans on back of the unit.
Adequate air flow
is required for safe operation.
4.
Cable space - Allow for proper bend radius of the fiber cables exiting the front of the unit. Do not exceed the
recommended minimum bend radius of the fiber cable.
Device Mounting Options
Introduction
The Nitek FRS2020 unit provides a means of centralizing individual video data modules, from the FSS20111S system,
together in a single chassis. The FRS2020 uses the standardized dimensions for a 19 inch 2-Unit rack mounted
chassis. The chassis can accommodate, in any combination, of up to 16 video card modules from the FSS20111S
system. The chassis design supports ‘hot swapping’ of the FSS20111S ‘plug and play’ video cards, allowing the system
to be powered up while cards are removed and installed. The FRS2020 is configured as a dual power supply, both
power supplies work independently from each other. In the case of a major failure by one of the power supplies the
other supply will continue to provide the proper power to all of the video cards.
