Chassis Fan Replacement Guide
10
ni.com
8.
Insert three of the four screws with the flat washers closest to the fan
and the split spring washers closest to the screw heads. The fourth
screw does not use washers, but instead anchors the thermistor. Insert
the fourth screw through the thermistor clip hole and orient the
thermistor as shown in Figure 8.
Figure 8.
Thermistor Location and Orientation
9.
Tighten the screws to between 5.7 lb · in. minimum torque and
6.7 lb · in. maximum torque.
10. Place the fan access panel over the opening. Insert and tighten the
access panel screw to between 3.0 lb · in. minimum torque and
3.6 lb · in. maximum torque.
Caution
Reorient the chassis to an upright position and ensure there are no loose parts
prior to plugging in the power cord.
1
Grommet
2
Thermistor and Clip
2
1
