Chapter 3
PXI-8150B Series Configuration and Installation
©
National Instruments Corporation
3-5
Ethernet Power-on Defaults
The PXI-8150B Ethernet circuitry loads its power-on settings from an
EEPROM. Do not change switch W1 from its default setting as shown in
Figure 3-4a. Figure 3-4b shows the alternate position only for
informational purposes.
Figure 3-4.
Ethernet Power-on Defaults
LCD Output (PXI-1020 Chassis)
When using the PXI-8150B Series controller with an PXI-1020 chassis,
you can select whether the LCD is enabled while booting or off until the
operating system loads and software turns it on. Use both the W3 and W4
jumpers to change the LCD output settings. Figure 3-5 shows the LCD
output configuration options.
Figure 3-5.
LCD Output Settings
W1
a. Ethernet Power-on Defaults
Loaded from EEPROM
b. Hardwired Ethernet Values
W1
W3
W4
W4
W3
a. LCD Output on
during Boot (default)
b. LCD Output off
during Boot
LCD Output Settings