Chapter 2
Installation and Configuration
2-2
ni.com
4.
Remove the protective plastic covers from the four bracket-retaining
screws as shown in Figure 2-1.
Figure 2-1.
Removing Protective Screw Caps
5.
Make sure the injector/ejector handle is in its downward position.
Align the NI PXI-8110 with the card guides on the top and bottom
of the system controller slot.
Caution
Do
not
raise the injector/ejector handle as you insert the NI PXI-8110.
The module will not insert properly unless the handle is in its downward position
so that it does not interfere with the injector rail on the chassis.
1
Protective
S
crew C
a
p (4X)
1
