NI PS-15/16/17 Side Mount Brackets Installation Guide
4
ni.com
Assembly and Mounting Instructions
This section provides instructions for mounting the power supply sideways
to a panel or to a DIN-Rail.
Note
The two aluminum brackets and the black plastic slide must be removed from the
units to allow mounting of the zinc-plated steel brackets.
Sideways Panel Mounting
Complete the following steps to mount the brackets to a flat wall.
1.
Detach the two aluminium brackets by removing the four screws with
a Torx 10 screwdriver, as shown in Figure 4.
Figure 4.
Removing the Aluminum Brackets
2.
Remove the plastic lock mechanism with a flathead screwdriver to
move the lock downward while at the same time pushing the plastic
slider upwards. Detach the plastic slider, as shown in Figure 5.
